上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
31 / 97
4.6 Execute Fixed Calibration
This operation is applicable to general NK105 with double Z axes. And it is used to
measure the tool on a certain fixed position of the machine tool to reconfirm tool
offset. It helps to avoid tool length and the clamping position vary during machining
due to tool damage or other causes.
About tool offset parameters, see Tool Change.
You can use the same tool sensor to execute calibration for Z1-axis and Z2-axis in
turn.
Before executing fixed calibration, set the tool number.
To execute fixed calibration, do the following:
1. To respectively set the tool length for Z1-axis and Z2-axis, press +
/ + . The prompt Set tool length of Z1-axis / Z2-axis,
continue? appears.
2. Press . The prompt Succeeded in setting tool length of Z1-axis / Z2-axis.
appears.
3. Press for confirmation.
4. To reconfirm tool offset, press + .
To Next Page
Loading...
