WEIHONG NK105 - Adjust the Port Polarity

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
12 / 97
1.3.2 General NK105 with Double Z Axes
The main interface is as follows:
1. Activated axes
2. Coordinates
3. Operation status
– Idle: Default status.
– Running
– Pause
– Stop
– Locked: NK105 is locked when the soft limit is triggered.
4. Spindle status and coordinate system
– Spindle status
• Enabled
• Disabled
– Coordinate system
When the coordinate system turns to show the MCS, this area shows G53;
when it turns to the WCS, this area shows G54 (default one) / G55 / G56
/ G57 / G58 / G59.
5. Speed mode
– High-speed jog
– Slow jog mode
6. Motion mode
– Jog: Finely adjust the machine coordinate.
– Step: Coarsely adjust the machine coordinate.