上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
32 / 97
4.7 Start Machining
This operation is used to start to machine the program file.
During machining, to check the current loaded program file, machining time and
machining line, press in the main interface:
To start machining, press .
4.8 Adjust Machining
During machining, do one of the following according to your need:
• Adjust the feedrate override.
• Adjust the spindle speed.
• Execute the fine adjustment.
• Handle the soft limit.
• Handle the hard limit.
4.8.1 Adjust the Feedrate Override
You can adjust the actual feedrate by the feedrate override. This operation is used to
adjust the feedrate override within 0% ~ 120%.
Every time you press related buttons to adjust the feedrate override, the feedrate
override increases / decreases 10%.
To adjust the feedrate override, press / .
To Next Page
Loading...
