上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
37 / 97
– If it is your first time to set the machining wizard, do the following:
1. Select 1. Params Setting by pressing / , press
, and set parameters.
Note: If parameter Engraving depth is too large, when a program file is loaded,
the warning Too many file layers generated. Continue? appears. At this time, it is
prohibited to press any button.
It is default to show the first four parameters, and you can check
and set the others by pressing arrow buttons.
About parameter details, see Machining Wizard.
2. To load the program file, select Load Now by pressing /
, and press .
5.2 Execute Selective Machining
This operation is used to customize the start line and end line for machining.
To execute selective machining, do the following:
1. To enter the menu interface, press .
2. To enter the operation interface, select 3. Operations by pressing /
, and press .
To Next Page
Loading...
