WEIHONG NK105 - 1 System Overview; NK105 (E) Control Box with Four Axes

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
1 / 97
1 System overview
NK105 Integrated CNC System (Hereinafter referred to as NK105) is an integrated
CNC system with three or four axes, based on embedded industrial control platform
and independently developed by Weihong Company.
According to axes, NK105 has the following types:
• General NK105 with three axes: Including X-axis, Y-axis and Z-axis.
• General NK105 with four axes: Including X-axis, Y-axis, Z-axis and A-axis.
• General NK105 with double Z axes: Including X-axis, Y-axis, Z1-axis and Z2-axis.
Hardware
• NK105(E) control box with four axes / NK105 control box with three axes
The two control boxes are almost the same, except the former supports A-axis
or Z2-axis.
This manual takes NK105(E) control box with four axes as an example.
• NK105G3 handheld box.
Software
About the main interface of NK105, see Main Software Interface.
1.1 NK105 (E) Control Box with Four Axes
This section introduces the schematic diagram and dimension drawing o f NK105 (E)
control box with four axes.
This control box, an integration of the system control card, terminal board and other
parts, connects to the handheld box with 15-core connecting cable. And the up and
down ends at its back are for terminals and the left side is for the USB interface and
DB15 interface.