Weinmann MEDUMAT Standard2 - Page 57

WM 68071 05/2021
MEDUMAT Standard
2
EN 57
4 Preparation and operation
3. With the reusable breathing circuit: Connect the connector
with CO
2
connection:
• to the patient valve
or
• to the FlowCheck sensor
4. With the reusable breathing circuit: Connect the CO
2
measuring tube to the connector with CO
2
connection.
5. With disposable breathing circuits: Detach the blanking plug
on the CO
2
connection and connect the CO
2
measuring tube
to the CO
2
connection.
When doing so, note: Tighten the screw connection by hand.