WM 68071 05/2021
MEDUMAT Standard
2
EN 67
4 Preparation and operation
Depending on the preset in the operator menu, the device
switches to one of the following modes with the ventilation
parameters preset for the patient group (see "14.1.10 Factory
settings for emergency modes and ventilation modes",
page 257) and shows a pressure gauge view:
•IPPV
• BiLevel + ASB (only with activated BiLevel + ASB option)
Result An emergency mode for a particular patient group is activated.
4.7.2 Calling up the parameters of the patient last
ventilated
Requirement The device is switched off.
1. Switch on the device.
After the self-test, the device displays the start menu:
If the device was switched off for < 30 seconds (e.g., for a
battery replacement), a countdown in the Previous patient
field counts down 20 seconds.
If the device was switched off for > 30 seconds, the
countdown for the last patient is deactivated.
To Next Page
Loading...
