12
Indicator Technical Manua
Closing the M1 Enclosure
1. Once wiring is completed, replace the back cover over the main
enclosure.
2. Re-install the back cover screws being careful not to over-tighten.
3. Observe the back cover gasket is providing a good seal.
Mounting Instructions
1. The M1 can be mounted to horizontal or vertical surfaces using the
mounting bracket.
2. Ensure that mounting structures (walls, posts, etc.) will bear the weight of
the indicator (Approx. 1.5 kg / 3.5 lbs).
3. Use proper hardware, including wall anchors where necessary, when
mounting the bracket and indicator.
Warning! Over-tightened screws may compress and deform the
back cover gasket, resulting in gasket failure.
To Next Page
Loading...
