Western Scale M1 - Ticket Formatting Sub-block 7.x

22
Indicator Technical Manua
l
Ticket Formatting Sub-block 7.x
Parameter Value Description
P7.0
Enable
Ticket Editor
0 = Disabled <
1 = Enabled-
Enables access to the Ticket Editor. Once
enabled, access the Ticket Editor in Weighing
Mode by holding the PRINT key for 3 seconds.
This parameter remains enabled until the
indicator power is cycled.
The indicator supports 5 tickets (numbered 1 to
5). Ticket 1 is always assigned to the PRINT
key. Tickets 2-5 are called from the MENU key.
A simple factory ticket (time, date, gross, tare,
net) is included as Ticket 1. Please see the
MACRO II Ticket Programming Manual for more
information on creating tickets.
P7.1
Delete Single
Ticket
del 0 <
Range: 0 - 5
Select a ticket (1 to 5) to delete. Enter 0 to exit if
a ticket is not to be deleted.
P7.2
Delete All
Tickets
PASSWORD
Delete ALL tickets. All ticket memory is erased.
Calibration password is required.
P7.3
Print Lockout
Threshold
000010 <
This parameter is used in conjunction with C36 to prevent
multiple printouts of the same weight transaction.
Enter the weight threshold the scale has to go below in
order to reset Print Lockout.
This parameter is used with accumulation and serial
numbering, preventing the ticket from being executed again
until the scale goes below the Print Lockout Threshold.
Place C36 before any counting and accumulation functions
to prevent counting the same transaction twice.
Everything before C36 will still print. The ticket stops
printing when C36 is evaluated true.
See the C36 macro control code in the MACRO II Ticket
Programming Manual for more information.
Factory default values are bold <.