Windhager LogWIN Klassik - Page 97

46
4. For the Service Technician
Fig. 115
Update Software
MAC-address
0C-E5-D3-00-00-05
start back
Update Software
Der Update-Vorgang zur Aktualisierung der InfoWINplus Software über die
Ethernet Schnittstelle wird gestartet.
Fig. 116
Update LON
start back
Update LON
The update procedure for updating the LON Controller firmware is being star-
ted. The LON Controller firmware is included in the InfoWINplus software,
therefore no external update tool is required.
Fig. 117
Display contrast
Correction 5
– back +
Display contrast
Adjusters to change the contrast of the display.
Factory setting: 5
Setting range: 0 – 10
Fig. 114
Ethernet
IP-Adresse 192.168.1.2
Subnet 255.255.255.0
Gateway 255.255.255.255
Choose Back
Ethernet
Setting the IP address, subnet mask and gateway address of the Ethernet
interface of InfoWINplus.
Factory setting: IP-Adresse 192.168.1.2
Subnet 255.255.255.0
Gateway 255.255.255.255
Fig. 113
ELG
Yes
No
Save Back
ELG
These functions are not yet available.
MB
Yes
No
Save Back
MB (Master operation)
Setting to define whether MESplus system control is present.
Factory setting: is set in the factory before delivery as per the order.
Selection: yes: with MESplus system control
no: no MESplus system control
Fig. 111
SMS
Yes
No
Save Back
SMS
is set in the factory before delivery as per the order.
Factory setting: wird je nach Bestellung werkseitg vor der Auslieferung
eingestellt.
Selection: yes: with remote switching
no: no remote switching
Fig. 112