WPC 2000 User Manual 1128500
Troubleshooting 5-15
Problem: A light curtain is connected with Two-hand Only firmware installed in WPC 2000.
Remedy: Remove the Two-hand Only firmware, and install a firmware version intended for
use with a light curtain, referring to Installing Revised Firmware in WPC 2000,
page 2-49. Contact Wintriss Tech. Support for help in selecting the right firmware
for your application.
Emergency-stop Circuit Driver Failure
Problem: The Emergency-stop input circuit driver has failed or is about to fail.
Remedy: Check E-stop circuit wiring, and correct any problems. If the error persists after
you reset the unit, contact Wintriss Tech. Support for assistance or replacement of
the driver.
Top-stop Circuit Driver Failure
Problem: The Top-stop input circuit driver has failed or is about to fail.
Remedy: Check Top-stop circuit wiring, and correct any problems. If the error persists after
you reset the unit, contact Wintriss Tech. Support for assistance or replacement of
the driver.
F65
F66 or H66
F67 or H67
To Next Page
Loading...
Need help?
General
