WPC 2000 User Manual 1128500
Troubleshooting 5-11
Problem: E-stop inputs were in different states (i.e., open or closed) for longer than 100 mS.
Remedy: Check the E-stop circuit wiring and the E-stop buttons.
Inter-processor Failures
Problem: One of the following processor errors has occurred:
Remedy: Try pressing Reset/Select. If error persists, contact Wintriss Tech. Support.
F27
F30* through F37*
and
H38* and H39*
F30 Resolver angles for A and B processors disagree by more than 2°
F31 No reply to Check Start request received from second processor
F33 Incorrect reply to Mode Change message received from second processor
F34 No reply to Mode Change message received from second processor
F35 Incorrect reply to Power-up message received from second processor
F36 No reply to Reset Error message received from second processor
F37 No reply to Compare Input Buffers message received from second
processor
H38 Second processor did not receive Power-up information correctly
H39 Second processor did not receive Mode information correctly
To Next Page
Loading...
