Installation 2-1
Chapter 2. Installation
IMPROPER INSTALLATION, USE OR MAINTENANCE
• Follow all procedures in this manual. Perform only the tests and repairs listed in this manual.
Use only factory-supplied replacement parts.
• Ensure that WPC 2000 clutch/brake control is installed, tested and repaired by qualified
personnel.
• Wire, install and maintain WPC 2000 clutch/brake control in accordance with the applicable
safety standards. Carry out all inspection procedures in OSHA 1910.217.
• Wire and install all equipment in accordance with the requirements of OSHA 1910.147 Control
of Hazardous Energy (Lockout/Tagout).
• Install and maintain your machine guarding system according to OSHA standard 1910.217,
ANSI B11.1, ANSI B11.19 and any other regulations and standards that apply. Ensure that
guarding is properly installed to prevent access to the machine over, under or around any
guarding device.
• Perform the checkout sequence after installation and after any modification or repair of the WPC
2000 clutch/brake control.
• Lockout/Tagout the press during all installation, modification, repair or maintenance procedures.
• Ensure that supervisors, die-setters, maintenance persons, machine operators, foremen, and
any others responsible for operation of the machinery have read and understood all instructions
for use of the WPC 2000 clutch/brake control.
• Disconnect the “Continuous” mode position of your stroke selector switch and cover the “CONT”
label on your control if the press is not properly guarded for use in Continuous mode.
Failure to comply with these instructions will result in death or serious injury.
FAULTY INSTALLATION
• Ensure that wiring is correct.
• Use only safety-certified components for safety functions, including interlock switches used in
safety applications.
• Install guarding to prevent access to hazardous areas. Prevent access to hazardous areas
over, under, or around any guarding devices.
• Ensure that there is one active Operator Station for each operator if you are using Two-hand
mode.
Failure to comply with these instructions will result in death or serious injury.
To Next Page
Loading...
