Software | Settings
Illumination (optional)
Touch the
illumination
pad until the desired colour
appears
The next colour is chosen every time you touch it.
See below for the sequence of the illumination colours.
The start position is always the set colour.
• Positions 1–16: preset colours
• Position 17: light sequence (permanent colour change)
• Position 18: freeze actual colour
• Position 19: LED illumination “off”
Milk (optional)
The empty milk message can be activated here.
Touch
Milk
Beverage lockout yes / no
Beverage lockout no
Beverages can be dispensed until the milk container is
actually empty.
Beverage lockout yes
Input is requested as to how many beverages can be
dispensed after the message has appeared. After this
number of beverages has been dispensed, beverages with
milk are blocked from further dispensing. Beverage lockout
is removed when the milk container is filled.
Intro
The start-up program is started here again.
After the last position, the loop
starts again at position 1.
Milk
illumination
To Next Page
Loading...
Need help?
General
