Messages and instructions
8.3 Errors without error message
Error pattern Action instructions
No hot water dispensing
but water in grounds
container
Clean hot water spout
Call WMFService (coffee dispensing possible)
No Choc dispensing but
water in grounds container
Do not use Choc dispensing
Call WMFService (coffee dispensing possible)
Choc portion controller
blocked, Choc dispensed
only with water
Clean portion controller
w Care w Product hopper cleaning, page 47
Empty powder
Turn dosing auger manually until all powder is removed
If necessary rinse with water
(Allow to) dry completely
Coffee dispensing on the
left/right differs
Clean the combi spout
w Cleaning instructions
No milk foam/milk output,
but milk in milk container
Check whether the milk hose is kinked or squashed
Re-route milk hose correctly
Clean the combi spout
Check whether milk nozzle is blocked
w Cleaning instructions
Check whether milk cooler is iced
Milk foam incorrect,
temperature too cold or
too hot
Change milk nozzle
- green milk nozzle for cooled milk
- white milk nozzle for uncooled milk
Clean the combi spout
w Cleaning instructions
The milk cooler does not
cool
Check if the milk cooler has been properly turned on
using the separate switch
Pump runs continuously,
water in grounds container
Switch off the coffee machine and on again
If error not remedied call WMFService
Milk foamer
and water tank:
assembly/disassembly stiff
Lightly smear the O-rings with WMFgasket grease
w Instructions in Customer Check-up Kit.
Choc/Topping hopper
cannot be replaced
Manually turn the drive for the dosing auger at the
portion controller slightly in aclockwise direction
To Next Page
Loading...
Need help?
General
