Safety
Safety Instructions
Safety 60HDdoc081208 1-10
1
USE PROPER PROCEDURE WHEN CONDUCTING ELECTRICAL SAFETY CHECKS
AND MAINTENANCE
DANGER! Make sure all electrical installation, service and/or
maintenance work is performed by a qualified electrician and is in
accordance with applicable electrical codes.
DANGER! Hazardous voltage inside the electric boxes and at the
motor can cause shock, burns, or death. Disconnect and lock out
power supply before servicing! Keep all electrical component cov-
ers closed and securely fastened during mill operation.
WARNING! Consider all electrical circuits energized and danger-
ous.
WARNING! Never assume or take the word of another person that
the power is off; check it out and lock it out.
WARNING! Do not wear rings, watches, or other jewelry while
working around an open electrical circuit.
WARNING! Before performing service near moving parts such as
blades, pulleys, motors, belts and chains, first turn the key switch
to the OFF (#0) position and remove the key. If the key is turned on
and moving parts activated, serious injury may result.
WARNING! Remove the blade before performing any service to
the engine or sawmill. Failure to do so may result in serious injury.
To Next Page
Loading...
Need help?
General
