Sawmill Setup
Sawmill Setup
3
3-1 60HDdoc081208 Sawmill Setup
SECTION 3 SAWMILL SETUP
3.1 Sawmill Setup
IMPORTANT! Before starting to use the sawmill you have
to meet the following conditions:
Set up the sawmill on firm and level ground.
The sawmill can be operated with the sawdust collection system only.
The sawmill can be operated under roof only.
The sawmill can be operated in temperature range from 5
o
C to 40
o
C only.
The sawmill operator’s position is shown below.
Have a qualified electrician install the power supply (according to EN 60204
Standard). The power supply must meet the specifications given in the table
below.
3-Phase
Volts
Fuse disconnect Suggested Wire Size
400 VAC 40 A
6 mm
2
up to 15 m long
TABLE 3-0
!
To Next Page
Loading...
Need help?
General
