Sawmill Operation
Water Lube Operation
Sawmill Operation 60HDdoc081208 4-16
4
4.10 Water Lube Operation
The Water Lube System keeps the blade clean. Water flows from a 5-gallon (18.9 liter)
bottle through a hose to the blade guide where the blade enters the log. A valve in the
bottle cap controls the amount of water flow.
See Figure 4-6.
A solenoid valve will automatically start the water flow when the power feed is activated in
the forward direction. The solenoid will stop the water flow when the feed switch is
returned to the neutral position.
Not all types of wood require the use of the Water Lube System. When it is needed, use
just enough water to keep the blade clean. This saves water, and lowers the risk of stain-
ing the boards with water. Usual flow will be 1-2 gallons (3.8-7.6 liters) per hour.
Before removing the blade, engage the blade. Let the blade spin with water running on it
for about 15 seconds. This will clean the blade of sap buildup. Wipe the blade dry with a
rag before storing or sharpening.
For further lubrication benefits, add one 12oz. bottle of Wood-Mizer Lube Additive to 5
gallons of water. Wood-Mizer Lube Additive enables some previously impossible timbers
to be cut by significantly reducing resin buildup on the blade. It helps to reduce heat
buildup, wavy cuts, and blade noise. This biodegradable and environmentally friendly
pre-mix includes a water softener additive, so it works with hard water.
FIG. 4-6
Turn valve counterclockwis
To Next Page
Loading...
Need help?
General
