Assembly
Sawhead Installation
Assembly LX55 9/17/20 3-3
3
4. Tighten tube, legs, and bracket with the M10x 80mm carriage bolts.
5. Insert the fastened tubes into the mast guide brackets.
6. Insert the head locking pins to prevent the head from sliding off the mast. See Fig. 3-2.
FIG. 3-1
FIG. 3-2
Upper mast tube
Bolt, M10-1.5x80mm
Carriage
Scale Mount Bracket
Mast Leg
Nut, M10 Flanged
Nylon Lock
Infeed Bracket
(ELECTRIC ONLY)
Locking Pins
NOTE: Position the sawhead on a bench/flat
surface at least 24” (0.6m) off of the ground.
Mast guides are shipped
loose. Do not tighten
at this time!
To Next Page
Loading...
