Wood-mizer LX55 - 3.12 Water Bottle Installation; 3.13 Blade Height Scale Installation

Assembly
Water Bottle Installation
3
3-26 LX55 9/17/20 Assembly
3.12 Water Bottle Installation
1. Install the water bottle tray to the mast cross tube using the M8x75mm bolts. See Fig.3-36.
2. Connect the hose between the water bottle and the idle side blade guide, using the hose clamp.
3.13 Blade Height Scale Installation
1. Apply scale decal 3/4” down from the top of the height scale bracket (if not pre-applied).
2. Open the sawhead cover to install the blade height scale bracket.
3. Use M8x20mm carriage bolts to attach blade height scale to the sawhead cover. See Fig. 3-37.
FIG. 3-36
55001-28
Blade guide hose fitting
Bolt, M8x75mm
Hose clamp
(on mast)
All slack in hose should be
above the hose clamp