Alignment
Saw Head Adjustment
Alignment LX55 9/17/20 4-4
4
b. Tighten the top and bottom jam nuts.
4.4 Saw Head Adjustment
1. Check that the tensioned blade is parallel to a bed rail. See Section 4.3.
2. Raise the sawhead approximately half way.
3. Measure the distance between the blade and the bed rail on both sides of the saw head.
4. Loosen the nylon mast guide.
FIG. 4-5
To tilt the wheel up, tighten the
top screw (loosening the bottom
one).
To tilt the wheel down, tighten
the bottom screw (loosening the
top one).
Alignment
Tool
To Next Page
Loading...
