Wood-mizer LX55 - Install the Motor (Electric Version Only)

Assembly
Install the Motor (Electric Version Only)
Assembly LX55 9/17/20 3-15
3
16. Install the exhaust deflector. See Fig. 3-22
3.9 Install the Motor (Electric Version Only)
1. Unpack the motor and its parts.
2. Set the motor on the motor mounting platform and loosely secure with M10x50mm bolts.
3. Insert the shaft key and the large bushing over the engine shaft. See Fig. 3-23.
NOTE: If the shaft key is too tight, file to fit.
4. Ensure the bushing is flush to the end of the shaft. See Fig. 3-23 .
5. Tighten the bushing set screw with a 3mm hex wrench. See Fig. 3-23.
6. Set the pulley over the bushing.
7. Secure the pulley with the bushing bolts. See Fig. 3-23
8. Tighten motor mount bolts.
9. Place belt over pulley.
FIG. 3-22
FIG. 3-23
55007-4
Direct exhaust up and
away from operator
550015-02
Key
Set bushing flush with shaft
Bushing bolt
Set screw
Pulley
Bushing