Assembly
Mount Lift System
3
3-24 LX55 9/17/20 Assembly
3. Adjust one saw head stop bolt to 1” (25mm) below the nylon mast guide.
4. Remove the head locking pins to lower the head to the lowest position.
5. Level the sawhead.
a. Set a level across the top of the sawhead.
b. Adjust the second stop bolt until the head is leveled.
6. Attach the lift cable to the bracket as shown in Fig. 3-32.
NOTE: Set lower lift cable nut to 1/4 of the way up from the bottom of the
threads to allow for adjustment.
7. Route the lift cable through the rollers as shown in Fig. 3-32.
8. Thread the lift cable through the hole in the lift shaft ends until all slack is taken up.
9. Tighten the set screw when the cable is tensioned.
10. Repeat on the other side of the sawhead.
11. Raise and lower the sawhead to check for additional adjustments.
FIG. 3-33
To Next Page
Loading...
