Maintenance
Troubleshooting
Maintenance LX55 9/17/20 6-5
6
Lumber is not square
Blade not parallel to bed rails Adjust bed rails.
Sawdust or bark between
log/cant and bed
Remove particles.
Tooth set problem Resharpen and reset blade.
Sawdust builds up on track
Track is sticky Clean track and apply silicone spray.
Worn wipers Adjust wipers to firmer contact track
or replace them.
Wavy cuts
Excessive feed Reduce feed speed.
Improperly sharpened blade
(This will be the problem 99% of
the time!)
Resharpen blade.
Blade guides improperly
adjusted
Adjust blade guides.
Sap buildup on blade, belts or
blade wheels
Use Water Lube.
Dull blade Sharpen or replace.
Not enough blade tension Adjust clutch cable for more tension.
Tooth set problem Resharpen and reset blade.
To Next Page
Loading...
