Owner Service 17
32394 (Rev. 9/3/2004)
Figure 6. Lubrication Points
:
DB1136A
REF
NO
DESCRIPTION FREQUENCY
1 Tailwheel hub 10 hrs.
2 Ratchet height adjustment (optional) 100 hrs.
3 Tailwheel pivot and hub (single or dual optional on mounted units) 10 hrs.
4 PTO Shaft, (mounted) lube all four sides of shaft and both U-joints (see * in fig-
ure 6)
Daily
5 PTO Shaft, (pull-type) access under shield; lube all four side of shaft next to
round tube
Daily
6 Gearboxes, check that all three are half full with a high quality gear lubricant
with a viscosity index of 80W or 90W and an API service rating of GL-4 or 5 in
gearbox(es)
Daily
7 PTO Shaft, front and rear U-joints 10 hrs.
8 Center U-joint on 3-joint drive (pull-type) 10 hrs.
9 Torsion bars - To prevent torsion bars from seizing and/or binding and causing
excessive loads on gearbox bearings, lubricate as detailed
At storage and
start of season
10 Hanger bearing assembly 10 hrs.
To Next Page
Loading...
