Woods 208-2 - M208-2 Rear Drive Assembly with Tri-Lobe Telescopic Shaft

48 Parts
32394 (Rev. 9/3/2004)
M208-2 REAR DRIVE ASSEMBLY WITH TRI-LOBE TELESCOPIC SHAFT (MOUNTED UNITS)
27
23
22
21
14
4
6
10
12
9
13
19
26
25
24
20
18
17
17
16
15
7
9
10
8
1
3
6
5
4
2
11
M5201
NOTE: Four Styles of driveshafts have
been used on the 208 series cutters.
Check your driveshaft for square, splined,
tri-lobe, or two--lobe shape and order
repair parts from the correct parts list.
REF PART QTY DESCRIPTION
1 53477 1 Drive, profile shield 60 25.81 x 1.38
QD
2 30961 1 Yoke - 60 1.38 6B QD
3 30913 1 1-3/8 Push pin set
4 30962 2 Kit, U-joint repair 60
5 53478 * 1 Yoke & tube, profile 60 x 33.8
6 30964 1 Kit, shield bearing 60
7 NSS 1 Shield bell assembly
8 NSS 1 Shield tube
9 30922 6 Retainer shield
10 30917 2 Chain shield tether
11 53479 * 1 Shield non-rotating 3.19 x 3.00 x 33.7
(includes items 6 - 10)
12 NSS 1 Shield tube 2.95 x 2.76 x 35.6
13 NSS 1 Shield bell kit 60 inner
14 53486 1 Yoke & tube profile 60 x 29.2
15 13927 6 HHCS 3/8 NC x 3-3/4 GR5
16 30953 1 Clutch yoke
17 19459 2 Friction disc 4 x 6.15
18 11576 1 Bushing 1-7/16 x 1-5/8 x 9/16 bronze
19 53442 1 Clutch hub (includes item 18)
20 6239 1 Nut lock 5/8 NC Hex
21 23141 1 HHCS 5/8 NC x 3-1/2 HT
22 6048 1 HHCS 7/16 NC x 3-1/2 GR5
23 13921 1 Lock nut 7/16 NC Hex
24 13931 1 Clutch back up plate
25 29687 6 Compression spring 1.15 x .26 x 2.2
26 12914 6 Lock nut 3/8 NC
27 53485 1 Shield non-rotating 2.95 x 2.76 x 25.8
(includes 6, 9, 10, 12 & 13)
* Items 5 & 11 are 33.8” long and must
be cut off to 25.8”
NSS Not Sold Separately
REF PART QTY DESCRIPTION