Woods 208-2 - M208-2 Integral U-Joint Shielding 1-1;2” Square Shaft

Parts 49
32394 (Rev. 9/3/2004)
208-2 & M208-2 SLIP CLUTCH ASSEMBLY WITH 1-1/2” SQUARE SLIP SLEEVE SHAFT
(PULL-TYPE & MOUNTED)
M208-2 INTEGRAL U-JOINT SHIELDING 1-1/2” SQUARE SHAFT (MOUNTED UNITS ONLY)
Ref Part No
No
No Used Description
1 9369 1 6S Clutch 1.5B & 1.5 SQ 30” Shaft (Pull-type
only) -- o r --
1 13878 1 6S Clutch 1.5B & 1.5 SQ 24” Shaft (Mounted
only)
2 17625 1 Yoke & 1-1/2 square shaft, 30” (Pull-type only)
-- o r --
2 12535 1 Yoke & 1-1/2 square shaft, 24” (Mounted only)
3 110 1 U-Joint repair kit
4 13931 1 6S Clutch back-up plate
5 19459 2 4 x 6.15 Friction disc
6 13928 1 6S Clutch yoke & plate
7 11576 1 1-7/16 x 1-5/8 x 9/16 Bronze bushing
8 13933 1 6S Clutch hub 1-1/2 (with bushing #7)
9 29687 6 2 GA x 2-3/16 Compression spring
10 12914 6 3/8 NC Wide flanged locknut
11 13927 6 3/8 NC x 3-3/4 Hex head cap screw GR5
12 13921 * 1 7/16 NC Hex locknut
13 6048 * 1 7/16 NC x 3-1/2 Hex head cap screw GR5
14 6239 * 1 5/8 NC Hex locknut
15 23141 1 5/8 NC x 3-1/2 Hex head cap screw GR5
* Obtain Locally
DB2160
A = 1.75”
NOTE: Four Styles of driveshafts have been used on
the 208 series cutters. Check your driveshaft for
square, splined, tri-lobe, or two--lobe shape and order
repair parts from the correct parts list.
OPTIONAL
Ref Part No
No
No Used Description
1 25123 1 Internal U-joint shielding complete
2 7398 2 Integral shield snap ring
3 4677 2 Nylon rectangular groove bearing
4 7359 1 26-3/8” Outer U-joint shield (front)
5 4775 1 Inner U-joint shield, 22-1/2” (rear)
STANDARD
Ref Part No
No
No Used Description
1 12581 1 Internal U-joint shielding complete
2 7398 2 Integral shield snap ring
3 4677 2 Nylon rectangular groove bearing
4 12579 1 20--3/4” Outer U-joint shield (front)
5 4775 1 Inner U-joint shield, 22-1/2” (rear)
DB2268