Woods 208-2 - 208-2 Rear Drive Assembly with Splined Telescopic Shaft

Parts 47
32394 (Rev. 9/3/2004)
208-2 REAR DRIVE ASSEMBLY WITH SPLINED TELESCOPIC SHAFT (PULL-TYPE UNITS)
1--COMPLETE DRIVE WITH CLUTCH
2
3
22
21
2
0
19
18
17
16
15
13
14
13
12
11
10
9
8
7
7
6
5
4
3
2
CD5027A
24--COMPRESSION SPRING REPAIR KIT
NOTE: Four Styles of driveshafts have
been used on the 208 series cutters.
Check your driveshaft for square, splined,
tri-lobe, or two-lobe shape and order
repair parts from the correct parts list.
REF PART QTY DESCRIPTION
1 53497 1 Drive assembly complete (includes
items 2 - 23)
2 12128 1 Ring snap .062 x 72mm
3 13133 1 1-1/2 Ball bearing
4 2985 1 1/4 - 28 Threaded 90° grease fitting
5 55140 1 Tubular shaft 1-5/16 - 20 splined 45-
1/2 long
6 13132 1 3-Joint drive bearing housing assem-
bly (includes items 2, 3, 4)
7 52394 2 Shield bearing kit
8 55142 1 Shield 2.75 x 2.03 x 38.9 (includes
item 7)
9 55141 1 Shield 3.02 x 2.84 x 28.75 (includes
item 7)
10 55139 1
1-5/16 Spline 30 long/ Yoke and
Shaft 35
11 110 1 U-Joint cross and bearing kit 35
12 13931 1 6S Clutch back-up plate
13 19459 2 Friction disc 4 x 6.15
14 13928 1 6S Clutch yoke and plate 35
15 13933 1 6S Clutch hub 1-1/2 with bushing
16 11576 1 1-7/16 x 1-5/8 x 9/16 Bronze bushing
(includes item 7)
17 12914 6 3/8 NC Wide flanged locknut
18 29687 6 Compression spring 1.15 x .26 x 2.2
19 13927 6 3/8 NC x 3-3/4 HHCS GR5
20 23141 1 5/8 NC x 3-1/2 HHCS HT
21 6239 1 5/8 NC Hex locknut
22 6048 1 7/16 NC x 3-1/2 HHCS
23 13921 1 7/16 NC Hex locknut
24 7283 6 Compression spring repair kit
(includes items 17, 18 & 19)
REF PART QTY DESCRIPTION