ELECTRICAL SYSTEM
STW34, STW37, STW40, WSM
9-S22
Front Wheel Turning Angle Sensor
1. Separate the arm (4) from angle sensor lever (5).
2. Disconnect the connector (1).
3. Remove the sensor with sensor cover (3), then remove the
sensor from sensor cover (3).
4. Measure the angle sensor resistance between the A terminal
(6) and ground C terminal (8).
5. Set the test lead of tester between B terminal (7) and ground C
terminal (8).
Turn the sensor lever (5) slowly and check the changing of
resistance value.
6. If measurement is not within the factory specifications, replace
it.
• If replaced a front wheel turning angle sensor, be sure to
operate the "Fine adjustment system".
9Y1211109ELS0027US0
Front wheel turning
angle sensor resistance
Factory
specifi-
cation
A terminal –
C terminal
4.32 to 6.48 kΩ
Changing of resistance
value
Factory
specifi-
cation
B terminal –
C terminal
Changing with smoothly
(1) Connector
(2) Front Wheel Turning Angle Sensor
(3) Sensor Cover
(4) Arm
(5) Lever
(6) A Terminal
(7) B Terminal
(8) C Terminal (Ground)
To Next Page
