Wunder-Bar JoeTap NITCOM - Page 34

Page | 34
x. Remove power connections to compressor and test:
• Remove Line (Black) and neutral (white) insulated terminals from inverter with needle nosed pliers.
See Figure 72a and 72b.
• Check line voltage (this is constantly energized from power harness); should be 120 V. See Figure 73.
• Unplug light blue wire (using tab to release). See Figure 74a and Figure 74b.
Figure 72a: Power connections being removed.
Figure 72b: Power connections shown removed.
Figure 73: Line Voltage being probed.
Figure 74a: Line Voltage being probed.
Figure 74a: Line Voltage being probed.