Wunder-Bar JoeTap NITCOM - Page 68

Page | 68
4.1.4. Insert two (2) Hose Clamps over each tubing. See Figure H15.
4.1.5. Insert the disassembled Elbow Shank into each one of the tubes on the Nitro Tower Tubing Assembly. See
Figure H16.
4.1.6. Secure the Elbow shank in place with two Hose Clamps. The Hose Clamps must face in opposite directions
and be parallel to the Elbow Shank. See Figure H17.
Figure H14: Lock Nut and Black Plastic Washer inserted over both tubing.
Figure H15: Hose Clamps over the both tubing.
Figure H16: Elbow Shank inserted into the tubing.
Curved Side of
Black Plastic
Washer facing
open end of tubes
Curved Side of
Lock Nut facing
open end of tubes
Elbow Shank
inserted into the
tubing
Two hose clamps
per tube