Insulation Blowing Machine M99
Page 18 of 51
X-Floc Dämmtechnik-Maschinen GmbH
Rosine-Starz-Straße 12 · 71272 Renningen · Germany
Phone +49-7159-80470-30 · Fax -40 | info@x-floc.com · www.x-floc.com
5.1.1 Switching the Machine On
Set the toggle switch [32] to position OFF [34] and the insulation blowing machine’s main switch Q1 [19] to
position “I”. The machine is now ready for operation.
WARNING!
Warning of automatic start-up!
Persons in the machine’s vicinity can be disturbed or taken aback from the automatic start-up.
Always set the toggle switch [32] to position OFF [34] before switching the insulation
blowing machine on.
Before putting the machine into initial operation, ensure that no one will be disturbed
due to the machine’s automatic start-up.
5.1.2 Machine Operation
To operate the machine, the control must always be connected with the electric switchboard’s [6] machine
control socket X3 [28].
Position Function Explanation
Air flow activation. Set the toggle switch [32] to position Air [35]. Air supply turns on.
Air and material flow
activation.
Set the toggle switch to position Material [33]. Air and material
flow turn on.
Air and material flow
deactivation
Set the toggle switch to position OFF [34]. Air and material flow, if
enabled, are turned off.
5.1.3 Cable Remote Control KFB
2000
The insulation blowing machine M99-DS-Pro can be operated using the cable remote control KFB
2000, see
chapter 7.1.1.
For information about operating the machine, please check the separate operating instructions for the
KFB
2000 or contact the customer service team.
To Next Page
Loading...
Need help?
General