Insulation Blowing Machine M99
X-Floc Dämmtechnik-Maschinen GmbH Page 7 of 51
Rosine-Starz-Straße 12 · 71272 Renningen · Germany
Phone +49-7159-80470-30 · Fax -40 | info@x-floc.com · www.x-floc.com
2.4 Safety Devices
In the event of functional interferences, the insulation blowing machine must be immediately shut down.
Interferences have to be rectified immediately. The insulation blowing machine may only be operated and
stored on sites where the temperature meets the operating requirements. Attention has to be paid to
sufficient air supply in order to avoid overheating. The insulation blowing machine may not be used on wet
surfaces or in rainy conditions. Hoses which are connected with metal parts can be recharged
electrostatically. An adequate grounding of metal parts reduces the potential risks of electrical discharging.
The electrical switchboard [6] is to be kept locked at all times upon initial commissioning and during the
operation. Access to this is only permitted for qualified electricians. Warning signs, coverings and protective
clothing may not be removed or changed. The insulation blowing machine’s movable parts pose a high risk
of injury.
DANGER!
Danger of injury upon initial commissioning and during operation of the insulation
blowing machine!
There is a higher risk of injury between the hopper extension [1] and the bottom of the machine [10].
Never tip over the machine during initial commissioning and/or operation!
Never grip the filling hopper [3] during initial commissioning and/or operation!
Never grip the area around the conditioning unit [9] during initial commissioning and/or
operation!
Prior to maintenance and cleaning work, move the net adaptor.
The workplace-related emission sound pressure level, measured according to DIN EN ISO 11201 is,
70.0 dB(A). Depending on local conditions, for example in an enclosed space, a higher sound pressure level
can occur.
The operator and persons, who are in the immediate proximity to the insulation blowing machine, must be
provided with all necessary protection gear. In the event of prolonged material afflux, the machine should be
switched off. When leaving the workplace, the machine must be stored securely in order to prevent
unauthorised and external influences from tampering the machine.
2.5 Spare Parts
Spare parts must comply with the manufacturer’s technical requirements. This is always guaranteed when
using original spare parts. X-Floc GmbH is not liable for any damages as a result of using improper spare
parts.
2.6 Insulation Materials
The insulation blowing machine may only be used with insulation materials which are authorised by
construction supervisory boards. If the machine should be used with non-authorised insulation materials and
hoses, then the potential threats of an electrostatic charge, which leads to in electrocution, and/or
interferences with the machine are imminent. X-Floc Dämmtechnik-Maschinen GmbH shall not be liable for
damage resulting from improper use to any persons or objects.
2.7 Resale
Should the insulation blowing machine be resold or passed on further, all accompanying documents must be
passed onto the new owner. To gain more information about the relevant safety changes on the insulation
blowing machine EM300, machines and accessories, the manufacturer’s registration is required. For more
information, please contact our customer service team.
To Next Page
Loading...
Need help?
General