Insulation Blowing Machine M99
Page 22 of 51
X-Floc Dämmtechnik-Maschinen GmbH
Rosine-Starz-Straße 12 · 71272 Renningen · Germany
Phone +49-7159-80470-30 · Fax -40 | info@x-floc.com · www.x-floc.com
5.2.6 Hand-held Control and Receiver Configuration
1. 2. 3. 4.
Figure 15: FFB
400 Hand-held control and receiver configuration
To configure the hand-held control and the receiver, the control must always be connected with the electric
switchboard’s [6] machine control socket X3 [28].
Screw on the receiver. Press the programme and delete button until the LED lights up and press the
Material [38] button. A successful configuration of the hand-held control and the receiver will be signalled via
short darkening of the LED. The program function will remain active for approx. 30 seconds and
automatically switch itself off thereafter. The LED doesn’t light up anymore. Up to 60 hand-held controls can
be configured with a receiver.
To delete the entire receiver’s configurations with the hand-held control, hold down the programme and
delete button for more than five seconds until the LED flashes.
5.2.7 Radio Remote Control FFB
2000-Pro
The insulation blowing machine M99-DS-Pro can be operated with the radio remote control FFB
2000-Pro,
see chapter 7.1.1.
For information about operating the machine, please check the separate operating instructions for the
FFB
2000-Pro or contact the customer service team.
To Next Page
Loading...
Need help?
General