Operation
Remote Control Modes
60 Operating Manual for XDC Series Power Supply
Remote Control Modes
A number of control interfaces are available. You can control the power supply
remotely using 0–5V or 0–10V signals via the remote analog programming interface
or from a remote terminal using a remote digital interface. A remote digital interface
following RS-232 protocol is standard. An optional remote digital interface
following IEEE 488.2 (GPIB) protocol is also available. An optional CANbus port
for 6000 Watt units is also available which enables multi-channel communication
from a single GPIB address, and supports current sharing with parallel connected
units. (For detailed information, see Section 4, “Remote Operation”.)
To Next Page
Loading...
