Xantrex XDC - Reading and Clearing Error Messages; Troubleshooting Error Messages

Operation
Power Supply Operation
80 Operating Manual for XDC Series Power Supply
To select a stored user setting:
To select a factory setting:
To select Auto Sequence:
For operation of Auto Sequence mode, see “Using Auto Sequencing” on page 97.
Step # Do This You Will See
1 Press twice. User Setting
2 Use the numeric keypad
or arrow keys to enter a value
between 1 and 10.
User Set ##
1
1. This prompt appears when there is at least one saved setting in memory. If there are no saved
settings, the display reads None Saved and then automatically returns to User Settings.
3 Use the numeric keypad
or arrow keys to enter a value
between 1 and 10.
Step # Do This You Will See
1 Press 3 times. Factory Preset
2 This restores the setpoints
to factory defaults.
Step # Do This You Will See
1
Press 4 times.
Auto Sequence
2
Use the numeric keypad
or arrow keys to enter a value
between 1 and 10.
User Set ##
1
1. This prompt appears when there is at least one saved programs in memory. If there are no
saved programs, the display reads None Saved and then automatically returns to Auto
Sequence.
3 This runs the selected
Auto Sequence program.
RECALL
ENTER
ENTER
RECALL
ENTER
RECALL
ENTER
ENTER