Maintenance
WorkCentre 6015 Color Multifunction Printer 157
User Guide
Adjustments and Maintenance Procedures
This section includes:
Color Registration .......................................................................................................................................................... 157
Adjusting Paper Type ................................................................................................................................................... 158
Adjusting the Bias Transfer Roller ........................................................................................................................... 158
Adjusting the Fuser ....................................................................................................................................................... 158
Refreshing the Bias Transfer Roller ......................................................................................................................... 159
Adjusting the Altitude .................................................................................................................................................. 159
Color Registration
The printer automatically adjusts the color registration when automatic adjustment is turned on. You can
also adjust color registration manually any time the printer is idle. You must adjust the color registration
any time the printer is moved. If you are having printing problems, adjust the color registration.
Setting Automatic Color Registration
1. On the printer control panel, press the System button.
2. To select Admin Menu, press the arrow buttons, then press OK.
3. Select Maintenance, then press OK.
4. Select Auto Regi Adjust, then press OK.
5. Select On, then press OK.
6. To return to the Ready screen, press Return.
Performing an Automatic Color Registration Adjustment
Automatic color registration adjustment occurs every time a new toner cartridge is installed. You can run
this adjustment at other times as needed.
To perform an automatic color registration adjustment:
1. On the printer control panel, press the System button.
2. To select Admin Menu, press the arrow buttons, then press OK.
3. Select Maintenance, then press OK.
4. Select Adjust Color Regi, then press OK.
5. At Auto Adjust, press OK.
6. At the Are you sure? prompt, press the arrow buttons to select Yes.
7. To begin the calibration, press OK.
To Next Page
Loading...
