Xerox B410 - LPD Configuration

MMEENNUU IITTEEMM DDEESSCCRRIIPPTTIIOONN
AAlllloowwaabbllee AAuutthheennttiiccaattiioonn MMeecchhaanniissmmss
• EAP - MD5 (On*)
• EAP - MSCHAPv2 (On*)
• LEAP (On*)
• PEAP (On*)
• EAP - TLS (On*)
• EAP - TTLS (On*)
• TTLS Authentication Method
– CHAP
– MSCHAP
– MSCHAPv2*
– PAP
Configure the allowed authentication mechanisms for
the 802.1x connection.
Note: An asterisk (*) next to a value indicates the factory default setting.
LPD CONFIGURATION
Note: This menu appears only in network printers or printers that are attached to print servers.
MMEENNUU IITTEEMM DDEESSCCRRIIPPTTIIOONN
LLPPDD TTiimmeeoouutt
0–65535 seconds (90*)
Set the time-out value to stop the Line Printer Daemon
(LPD) server from waiting indefinitely for hung or
invalid print jobs.
LLPPDD BBaannnneerr PPaaggee
• Off*
• On
Print a banner page for all LPD print jobs.
Note: A banner page is the first page of a print
job used as a separator of print jobs and to
identify the originator of the print job request.
LLPPDD TTrraaiilleerr PPaaggee
• Off*
• On
Print a trailer page for all LPD print jobs.
Note: A trailer page is the last page of a print
job.
LLPPDD CCaarrrriiaaggee RReettuurrnn CCoonnvveerrssiioonn
• Off*
• On
Enable carriage return conversion.
Note: Carriage return is a mechanism that
commands the printer to move the position of
the cursor to the first position on the same line.
Note: An asterisk (*) next to a value indicates the factory default setting.
130
Xerox
®
B410 Printer User Guide
Use Printer Menus