ENABLING MAGNIFICATION MODE
1. In one motion and using one finger, slowly swipe left then up on the display until you hear a voice message.
• For printer models without built-in speakers, use headphones to hear the message.
2. Using two fingers, do the following:
a. Touch MMaaggnniiffiiccaattiioonn mmooddee.
b. Touch OOKK.
If the gesture does not work, then apply more pressure.
For more information on navigating a magnified screen, refer to Navigating the Screen Using Gestures.
ADJUSTING THE DEFAULT HEADPHONE VOLUME
1. From the home screen, touch SSeettttiinnggss >> DDeevviiccee >> AAcccceessssiibbiilliittyy.
2. Adjust the headphone volume.
Note: The volume resets to the default value after the user exits Accessibility mode or when the printer
wakes from Sleep or Hibernate mode.
ADJUSTING THE DEFAULT INTERNAL SPEAKER VOLUME
1. From the home screen, touch the on-screen keypad icon.
2. Adjust the volume.
If Quiet Mode is enabled, then audible alerts are turned off. This setting also slows the printer performance.
The volume resets to the default value after the user exits Accessibility mode or when the printer wakes from
Sleep or Hibernate mode.
56
Xerox
®
B410 Printer User Guide
Set up, Install, and Configure
To Next Page
Loading...
