Xerox D95 User Manual

6. Run your print job.
• The paper is fed accurately without skew and the printed output is satisfactory;
your task is complete.
• The paper is skewed and the printed output is unsatisfactory; proceed to the next
step.
7. Pull out the tray slowly until it stops.
8. Return the rear skew adjustment lever to its left, default position.
9. Slide the right-side skew adjustment lever toward the front of the paper tray.
10. Gently push in the tray until it comes to a stop.
11. From the Tray Properties window, enter the correct paper information, including size,
type, weight, and if necessary, paper curl and/or alignment option.
12. Select OK to save the information and close the Tray Properties window.
13. Run your print job.
• The paper is fed accurately without skew and the printed output is satisfactory;
your task is complete.
• The paper is skewed and the printed output is unsatisfactory; proceed to the next
step.
14. Pull out the tray slowly until it stops.
15. Return the right-side skew adjustment lever toward the rear of the paper tray; this is
its default position.
16. Gently push in the tray until it comes to a stop.
17. If you are still having skew adjustment problems, refer to the Advanced Stock Setup
information located in the System Administration Guide.
OHCF problem solving
Clearing OHCF jams
Tip
Always ensure that all paper jams, including any small ripped pieces of paper, are cleared
before proceeding with your print jobs.
Note
Remedies differ according to the paper jam location. Follow the instructions displayed
to remove the jammed paper.
18-9Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
Oversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)

Xerox D95 Specifications

General

Print Speed	Up to 95 ppm
Print Resolution	2400 x 2400 dpi
First-Print-Out Time	As fast as 3.5 seconds
Duplex Printing	Yes
Standard Paper Size	A4
Max Paper Size	13 x 19 in.
Connectivity	Ethernet, USB
Finishing Options	Stapling, Hole Punching, Folding
Warranty	1 year