Maintenance
While performing maintenance activities, always keep the following items in mind:
• It is recommended that you perform all cleaning procedures on a daily basis,
preferably at the start of the day before the system is switched on and while the
fuser is cool.
• If the system is switched on and the fuser is hot, be sure to switch off the system
power and allow 30 minutes for the fuser to cool before performing any cleaning
procedures.
• Only clean the recommended areas of the paper path as described in the cleaning
procedures.
Cleaning the binder
1. Switch off the system by pressing the power button (which is located on the Print
Engine, Right Side).
2. Disconnect the power cord at the back of the binder.
3. Use a damp, water-moistened (not wet), lint-free cloth to clean the covers and doors.
4. Open each green-handle area and clean the surfaces of these areas.
5. Remove any residual moisture with a dry, lint-free cloth.
6. Return all the green levers to their original positions.
7. Reconnect the power cord to the binder.
8. Power on the system.
Empty the trimmer waste tray
Read the following before performing this procedure:
• Do not open the trimmer waste tray while the binder is in operation. Wait until the
completion of a job before opening and emptying the tray.
• Do not place a plastic bag into the tray. This reduces the capacity of the tray and
may cause equipment damage or fault codes to be generated.
• When the trimmer waste tray is full, the printer stops running and a message displays
stating that the bin is full and will resume after it is emptied.
User Guide21-20
Perfect Binder (D110/D125/D136 with integrated controller)
To Next Page
Loading...
Need help?
General