Xerox D95 User Manual

051-900
Cause: Paper jam
Remedy: Perform the following:
• Check for any obstructions or paper jams in the Finishing Module and Finishing
Transport paper paths and clear them.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
Third-party DFA fault codes
The following table provides a list of fault codes that indicate that a jam or fault has
occurred in the attached third-party, Document Finishing Architecture (DFA) device.
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
051-910
Cause: Either the DFA device is not ready or other fault has occurred with it
Remedy: Perform the following:
• Refer to any user documentation that came with your DFA device and follow the
instructions to bring the device back online.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
051-911
Cause: Either the DFA device is not ready or other fault has occurred with it
Remedy: Perform the following:
• Refer to any user documentation that came with your DFA device and follow the
instructions to bring the device back online.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
051-912
Cause: The DFA device is either full or out of supplies
Remedy: Refer to any user documentation that came with your DFA device and follow
the instructions to clear the fault and/or replenish the depleted supplies.
051-913
Cause: Paper jam in the DFA device
Remedy: Perform the following:
User Guide24-42
Standard Finisher Plus

Xerox D95 Specifications

General

Brand	Xerox
Model	D95
Category	Copier
Language	English