Xerox D95 User Manual

The Perfect Binder is an optional finishing device that takes the printed output and binds
it into a finished book; a front and back cover is included with the bound output.
Note
Depending on your machine configuration, the Perfect Binder requires either the Interface
Module or the Interface Cooling Module.The Perfect Binder also requires an optional
finisher, such as High Capacity Stacker, Standard Finisher, or Booklet Maker Finisher.
Important
The D110/D125 configurations require the Interface Module, while the D136
configuration requires the Interface Cooling Module.The Interface Module is not available
with the D95 Copier/Printer configuration.
The Perfect Binder can be used in three modes:
• Manual mode: Load the preprinted book block into the Perfect Binder compiler tray
and covers into Tray 9. Program the Perfect Binder settings using the copier/printer
UI and press Start to complete the job.
• Copy mode: Copy the book block and cover. Program the Perfect Binder settings using
the copier/printer UI and press Start to complete the job.
• Print mode: From the user’s computer, the book block and cover are programmed
using the print driver. Information and steps for submitting the job are available
through the print driver help screens.
Tip
For optimum efficiency with a minimal amount of time, refer to the Perfect Binder
chapter in this guide before using it.
1-11Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
Product Overview

Xerox D95 Specifications

General

Print Speed	Up to 95 ppm
Print Resolution	2400 x 2400 dpi
First-Print-Out Time	As fast as 3.5 seconds
Duplex Printing	Yes
Standard Paper Size	A4
Max Paper Size	13 x 19 in.
Connectivity	Ethernet, USB
Finishing Options	Stapling, Hole Punching, Folding
Warranty	1 year