Using the Operator Panel Menus and Keypad 156
• Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
• "Setting Initial Settings on the Operator Panel" on page 40
Values:
Maintenance
Use the Maintenance menu to initialize Non-Volatile Memory (NVM), configure the plain paper
quality adjustment settings, and configure the security settings.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• F/W Version
Purpose:
To display the version of the controller.
• Adjust Paper Type
Purpose:
To adjust the paper type.
Values:
•Adjust BTR
Purpose:
To specify the optimum voltage settings for printing for the transfer roller (BTR). To lower the voltage,
set negative values. To increase, set positive values.
The default settings may not give the best output on all paper types. If you see mottles on the print
output, try to increase the voltage. If you see white spots on the print output, try to decrease the
voltage.
NOTE:
• The print quality changes depending on the values you select for this item.
Values:
Yes Performs the initial settings for the printer.
No* Does not perform the initial settings for the printer.
Plain Lightweight
Heavyweight*
Labels Lightweight
Heavyweight*
Plain 0*
-3 – +3
To Next Page
Loading...
Need help?
General