Xerox WORKCENTRE 3210 User Manual

Installing Printer Software in Windows
6
N OTE : If your printer is not already connected to the computer, the
following window will appear.
• After connecting the printer, click
Next .
• If you don’t want to connect the printer at this time, click
Next , and No
on the following screen. Then the installation will start and a test page
will not be printed at the end of the installation.
• The installation window that appears in this User’s Guide may
differ depending on the printer and interface in use.
6 Select the components to be installed and click Next .
N OTE : You can change the desired installation folder by clicking
[ Browse ].
7 After the installation is finished, a window asking you to print a test
page appears. If you choose to print a test page, select the
checkbox and click
Next .
Otherwise, just click
Next and skip to step 9.
8 If the test page prints out correctly, click Yes .
If not, click
No to reprint it.
9 Click Finish .
Installing Software for Network Printing
When you connect your printer to a network, you must first configure the
TCP/IP settings for the printer. After you have assigned and verified the
TCP/IP settings, you are ready to install the software on each computer
on the network.
You can install the printer software using the typical or custom method.
Typical Installation
This is recommended for most users. All components necessary for
printer operations will be installed.
1 Make sure that the printer is connected to your network and
powered on. For details about connecting to the network, see the
supplied printer’s User’s Guide.
2 Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an installation window
appears.
If the installation window does not appear, click
Start and then
Run . Type X:\Setup.exe , replacing “ X ” with the letter which
represents your drive and click
OK .
If you use Windows Vista, click
Start → All programs →
Accessories → Run , and type X:\Setup.exe .
If the AutoPlay window appears in Windows Vista, click Run
Setup.exe in Install or run program field, and click Continue in
the User Account Control window.
3 Click Install Software .

Xerox WORKCENTRE 3210 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed	Up to 24 ppm
Duplex Printing	Manual
Monthly Duty Cycle	Up to 30, 000 pages
Processor Speed	360 MHz
Memory	128 MB
Standard Paper Capacity	250 sheets
Scanner Type	Flatbed, ADF
Fax Transmission Speed	33.6 Kbps
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, B5, Executive, Folio, Legal, Letter
Scan Resolution	Up to 4800 x 4800 dpi
Maximum Paper Size	8.5 x 14 in (Legal)
Operating System Compatibility	Windows, Mac OS
Print Resolution	600 x 600 dpi