Getting started_31
Using the save modes
Toner Save mode
Toner save mode allows your machine to use less toner on each page.
Activating this mode extends the life of the print cartridge beyond what
one would experience in the normal mode, but it reduces print quality.
1. Press Menu until System Setup appears on the bottom line of
the display and press OK.
2. Press OK when Machine Setup appears.
3. Press the left/right arrow until Toner Save appears and press OK.
4. Press the left/right arrow until the time setting you want appears and
press OK.
5. Press Stop/Clear to return to ready mode.
Power Save mode
Power Save mode allows your machine to reduce power consumption
when it is not in actual use. You can turn this mode on and select a
length of time for which the machine waits after a job is printed before it
switches to a reduced power state.
1. Press Menu until System Setup appears on the bottom line of
the display and press OK.
2. Press OK when Machine Setup appears.
3. Press the left/right arrow until Power Save appears and press OK.
4. Press the left/right arrow until the setting you want appears and
press OK.
5. Press Stop/Clear to return to ready mode.
Setting print job timeout
You can set the amount of time a single print job is active before it must
print.The machine handles incoming data as a single job if it comes in within
the specified time. When an error occurs while processing data from the
computer and the data flow stops, the machine waits the specified time and
then cancels printing if data flow does not resume.
1. Press Menu until System Setup appears on the bottom line of the
display and press OK.
2. Press OK when Machine Setup appears.
3. Press the left/right arrow until Job Timeout appears and press OK.
4. Press the left/right arrow until the time setting you want appears and
press OK.
5. Press Stop/Clear to return to ready mode.
Changing the font setting
Your machine has preset the font for your region or country.
If you want to change the font or set the font for special condition such as
the DOS environment, you can change the font setting as follows:
1. Ensure that you have installed the printer driver from the provided
software CD.
2. Select Printer Settings Utility in Start > All Programs > your printer
driver name.
3. Confirm if PCL is selected in Emulation Setting.
4. Click Setting.
5. Select your preferred font in the Symbol set list.
6. Click Apply.
Following information shows the proper font list for corresponding
languages.
• Russian: CP866, ISO 8859/5 Latin Cyrillic
• Hebrew: Hebrew 15Q, Hebrew-8, Hebrew-7
• Greek: ISO 8859/7 Latin Greek, PC-8 Latin/Greek
• Arabic & Farsi: HP Arabic-8, Windows Arabic, Code Page 864,
Farsi, ISO 8859/6 Latin Arabic
• OCR : OCR-A, OCR-B
To Next Page
Loading...
Need help?
General
