EasyManuals Logo

Xerox WORKCENTRE 3210 User Manual

Xerox WORKCENTRE 3210
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
68 _Maintenance
5. Insert a new transfer roller into place.
6. Grasp the handles on the print cartridge. Insert the cartridge until it clicks
into place.
7. Close the front cover. Make sure the cover is securely latched, and then
turn the machine on.
Replacing the pick up roller
1. Pull the tray open.
2. Release the latch of pick up roller unit with your finger and hold it slide
the pick up roller unit to the left.
3. Slide the right guide of the pick up roller unit to the right.
4. Position the pick up roller in the middle and pull it down to release.
5. Replace the new pick up roller and fasten it by doing steps reverse.
6. Insert the tray back into the machine.
MANAGING YOUR MACHINE FROM THE
WEBSITE
If you have connected your machine to a network and set up TCP/IP
network parameters correctly, you can manage the machine via Xerox’s
CentreWare IS, an embedded web server. Use CentreWare IS to:
View the machine’s device information and check its current status.
Change TCP/IP parameters and set up other network parameters.
Change the printer properties.
Set the machine to send email notifications to let you know the
machine’s status.
Get support for using the machine.
To access CentreWare IS:
1. Start a web browser, such as Internet Explorer, from Windows.
2. Enter the machine IP address (http://xxx.xxx.xxx.xxx) in the address
field and press the Enter key or click Go.
Your machine’s embedded website opens.
CHECKING THE MACHINE’S SERIAL NUMBER
When you call for service or register as a user on the Xerox website, the
machine’s serial number may be required.
You can check the serial number by taking the following steps:
1. Press Menu until System Setup appears on the bottom line of the
display and press OK.
2. Press the left/right arrow until Maintenance appears and press OK.
3. Press the left/right arrow until Serial Number appears and press OK.
4. Check your machine’s serial number.
5. Press Stop/Clear to return to ready mode.
If the front cover is not completely closed, the machine will not
operate.

Table of Contents

Other manuals for Xerox WORKCENTRE 3210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WORKCENTRE 3210 and is the answer not in the manual?

Xerox WORKCENTRE 3210 Specifications

General IconGeneral
Print TechnologyLaser
FunctionsPrint, Copy, Scan, Fax
Print SpeedUp to 24 ppm
Duplex PrintingManual
Monthly Duty CycleUp to 30, 000 pages
Processor Speed360 MHz
Memory128 MB
Standard Paper Capacity250 sheets
Scanner TypeFlatbed, ADF
Fax Transmission Speed33.6 Kbps
ConnectivityUSB 2.0, Ethernet
Media Sizes SupportedA4, A5, B5, Executive, Folio, Legal, Letter
Scan ResolutionUp to 4800 x 4800 dpi
Maximum Paper Size8.5 x 14 in (Legal)
Operating System CompatibilityWindows, Mac OS
Print Resolution600 x 600 dpi

Related product manuals