EasyManuals Logo

Xerox WORKCENTRE 3210 User Manual

Xerox WORKCENTRE 3210
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Getting started_25
getting started
This chapter gives you step-by-step instructions for setting up the machine.
This chapter includes:
Setting up the hardware
System requirements
Setting up the network
Installing the software
Machine's basic settings
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware which is explained in
the Quick Install Guide. Make sure you read Quick Install Guide and
complete following steps.
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow
extra space to open covers and trays.
The area should be well-ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the
altitude setting to optimize your printing. See "Altitude adjustment" on
page 29 for more information.
Place the machine on a flat, stable surface so that there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
2. Unpack the machine and check all the enclosed items.
3. Remove the tape holding the machine tightly.
4. Install the print cartridge.
5. Load paper. (See "Loading paper" on page 37.)
6. Make sure that all the cables are connected to the machine.
7. Turn the machine on.
SYSTEM REQUIREMENTS
Before you begin, ensure that your system meets the following
requirements:
Windows
Your machine supports the following Windows operating systems.
When you move the machine, do not tilt or turn it upside down.
Otherwise, the inside of the machine may be contaminated by toner,
which can cause damage to the machine or bad print quality.
OPERATING
SYSTEM
REQUIREMENT (RECOMMENDED)
CPU RAM
FREE HDD
SPACE
Windows
2000
Pentium II 400 MHz
(Pentium III 933 MHz)
64 MB
(128 MB)
600 MB
Windows XP Pentium III 933 MHz
(Pentium IV 1 GHz)
128 MB
(256 MB)
1.5 GB
Windows
Server 2003
Pentium III 933 MHz
(Pentium IV 1 GHz)
128 MB
(512 MB)
1.25 GB to
2 GB
Windows
Vista
Pentium IV 3 GHz 512 MB
(1024 MB)
15 GB
Internet Explorer 5.0 or higher is the minimum requirement for all
Windows operating systems.
Users who have an administrator right can install the software.

Table of Contents

Other manuals for Xerox WORKCENTRE 3210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WORKCENTRE 3210 and is the answer not in the manual?

Xerox WORKCENTRE 3210 Specifications

General IconGeneral
Print TechnologyLaser
FunctionsPrint, Copy, Scan, Fax
Print SpeedUp to 24 ppm
Duplex PrintingManual
Monthly Duty CycleUp to 30, 000 pages
Processor Speed360 MHz
Memory128 MB
Standard Paper Capacity250 sheets
Scanner TypeFlatbed, ADF
Fax Transmission Speed33.6 Kbps
ConnectivityUSB 2.0, Ethernet
Media Sizes SupportedA4, A5, B5, Executive, Folio, Legal, Letter
Scan ResolutionUp to 4800 x 4800 dpi
Maximum Paper Size8.5 x 14 in (Legal)
Operating System CompatibilityWindows, Mac OS
Print Resolution600 x 600 dpi

Related product manuals