Xerox WorkCentre 4118

Page 10-6 Xerox WorkCentre 4118 System Administration Guide
Administration Tools
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
¾ Select the [Status] tab and then select [Reset Network Controller] to enable the selection
to take effect.
Checking Configurations
Use these instructions to check the configuration settings of the WorkCentre 4118.
To check the configuration, perform these steps:
¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 10-4).
¾ At the CentreWare Internet Services Home Page for the WorkCentre 4118, select the
[Properties] tab.
¾ Select the plus symbol [+] to the left of the General Setup folder in the Properties frame.
¾ In the Properties frame, within the General Setup folder, select [Configuration].
The lower pane will show the firmware versions.
Click [Print System Data List] to print this report.
¾ In the upper pane, click the link for the settings that you want to check.
5
6
1
2
3
4
5