Xerox WorkCentre 4118 System Administration Guide Page 7-15
Network Installation Using Internet Services
SSDP
Use these instructions to configure the Simple Service Discovery Protocol (SSDP) using
CentreWare Internet Services.
Configure SSDP
To configure SSDP, perform these steps:
¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 7-5).
¾ At the CentreWare Internet Services Home Page for the WorkCentre 4118, select the
[Properties] link.
¾ Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and
then select the [+] symbol to the left of the Protocols folder.
¾ Select [SSPD] and check the Protocol Configuration details are correct. If any of the
details are incorrect then enter the correct information.
¾ Make the following selections and settings in the General section of the Protocols frame:
Select the checkbox to enable SSDP.
Enter the [Time to Live] (1 to 60 hops).
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
¾ Select the [Status] tab and then select [Reset Network Controller] to enable the selections
to take effect.
1
3
4
5
6
7
8
To Next Page
Loading...
Need help?
General
